MSA2324FC + MSA70
We have an MSA2324FC and we are wanting to add a single disk enclosure - an MSA70. We attach the MSA70 via a SAS lead and the disk enclosure is visible. All good so far.
# show enclosures
Encl Encl WWN Name Location Rack Pos Vendor Model EMP A BUS:ID Rev EMP B BUS:ID Rev
----------------------------------------------------------------------------------------------------------------------------------------
1 500C0FF0DAAC533C Enclosure 1 0 0 HP SPS-CHASSIS 0:31 1112 1:31 1112
----------------------------------------------------------------------------------------------------------------------------------------
Encl Encl WWN Name Location Rack Pos Vendor Model EMP A BUS:ID Rev EMP B BUS:ID Rev
----------------------------------------------------------------------------------------------------------------------------------------
5 5001438005A56100 Enclosure 5 0 0 HP MSA70 0:159 2.28 N/A
----------------------------------------------------------------------------------------------------------------------------------------
The problems occur when we add more than one disk to the disk enclosure. When we telnet to the MSA controller and run show disks, all the disks are listed, including the ones added into the MSA70. When we run show enclosures, we get the following error:
# show enclosures
A critical error has occurred. The Management Controller will reset.
We can run these commands with 1 disk inserted without the management controller resetting.
Any advice would be appreciated.
We dont know if these logs are at all relevant or helpful:
2019-02-22 11:10:45.663 CAPI_COMMAND_U_GET_SAS_DRIVE_ENCLOSURE_INFO
2019-02-22 11:10:45.760 getSASDriveEnclosureInfo: enclosureIndex=0 numPhysA0=36 numPhysB0=0 i=0
2019-02-22 11:10:45.762 Logging to debug log: criticality = ERROR "Get driveEnclosure(idx=0) SAS drive info failed(36, 0). "
2019-02-22 11:10:45.765 consumeEvent: Enclosure initialization complete event, processing end
Thank you.